2.2.4 Auto_beam_engraver

Generate beams based on measure characteristics and observed Stems. Uses baseMoment, beatStructure, beamExceptions, measureLength, and measurePosition to decide when to start and stop a beam. Overriding beaming is done through Stem_engraver properties stemLeftBeamCount and stemRightBeamCount.

Music types accepted:

beam-forbid-event

Properties (read)

autoBeaming (boolean)

If set to true then beams are generated automatically.

baseMoment (moment)

Smallest unit of time that will stand on its own as a subdivided section.

beamExceptions (list)

An alist of exceptions to autobeam rules that normally end on beats.

beamHalfMeasure (boolean)

Whether to allow a beam to begin halfway through the measure in triple time, which could look like 6/8.

beatStructure (list)

List of baseMoments that are combined to make beats.

subdivideBeams (boolean)

If set, multiple beams will be subdivided at baseMoment positions by only drawing one beam over the beat.

This engraver creates the following layout object(s):

Beam.

Auto_beam_engraver is part of the following context(s): CueVoice, DrumVoice, GregorianTranscriptionVoice, KievanVoice, MensuralVoice, PetrucciVoice, TabVoice, VaticanaVoice and Voice.


Internals Reference v2.17.97 (development-branch).